Farmall & IHC Tractors Discussion Board |
Re: SUPER A with a MOWER
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on October 19, 2004 at 18:16:40 from (209.226.106.172):
In Reply to: Re: SUPER A with a MOWER posted by Kendall on October 19, 2004 at 09:25:36:
Kendall: I have a home grown 3 point for my 130. Tractor is equiped with single point fast hitch, and if I wish to use the 3 point I just drop the fast hitch pull bar and install the 3 point lower links. It will easily lift 600 lbs with one point. The 3 point is a bit less as I cant get implements as close to tractor. Just one example on this I have a 60 IMP. gallon sprayer. My guess is full it weighs 800 lbs. Sprayer is 3 point, and I fabricated a one point adapter to get it closer to tractor. The one point hitch will lift the sprayer, full if I take about a 50 lb lift on back with my hands. I can not do that with the 3 point. I use a couple of check chains so sprayer weight is not on hydraulics when spraying. I also must use some front end weight. I have fabricated a number of implements for my tractors, and have used the one point. Key to this is getting implement weight close to tractor. I have a 6', 3 bar S tine field type cultivator, probably only weighs 400 to 500 lbs., but cultivator extends almost 6' back from rear tires. Tractor lifts it fine, but place 2 bags of fertilizer at very back and tractor will not lift. I also have 7 foot rotary hoe, weighs twice as much as the cultivator, but the weight is all within 2 feet of tractor wheels, and tractor lifts this no problems. On implements over 500 lbs, my advice is do everything you can to get weight close to tractor. Inches count on this one.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|