|
Farmall & IHC Tractors Discussion Board |
Re: Super A engine size
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on October 24, 2004 at 19:17:45 from (209.226.106.62):
In Reply to: Super A engine size posted by bcrosehill on October 24, 2004 at 14:37:46:
bcrosehill: All Super A prior to serial number 310300 had the C-113 engine. All Super A between serial number 310300 and 356001 had the C-123 block with thicker sleeves giving it still 113 cubic inches. All Super A after serial number 356001 had the C-123 engine complete with water pump. I am certain all Super A after serial number 310300 can be equiped with 3-1/8 bore sleeves and pistons to give the engine 123 cubic inches. It is my understanding all tractors prior to serial number can be equiped with 3-1/8 bore sleeves and pistons as well. I am not certain of this last statment. I am certain all Super A engines can be equiped with a water pump.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
