Re: 2 Point to 3 Point Conversion

Posted by r4etired on October 25, 2004 at 16:36:18 from (64.12.117.13):

In Reply to: 2 Point to 3 Point Conversion posted by GooseCreek Farms on October 25, 2004 at 03:46:19:

There should be 2 tappings in the the lift arms on each side. take a piece of 1/2 X 2in flat steel bend it to fit from the holes to the rock shaft then to the holes on the other side. Cut 2pieces of the flat stock 21/2 in long. Drill a 7/8 in hole in them , weld them in the center for your top link. If you use a strap around the rock shaft for the top link it is pretty sloppy when using a blade or any down pressure attachment MY 2 cents worth

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]