|
Farmall & IHC Tractors Discussion Board |
Hydraulics Don't move
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Matthew Johnson on December 13, 2004 at 17:14:29 from (64.71.69.39):
I purchased a Farmall 656 about four years ago.
Regular clutched, tractor, not hydrostatic.
It has ran very well for me and has never caused any problems. It always leaked alittle hydaulic fluid underneath the belly of the tractor but nothing bad.
I have occasionally checked the level and topped it off when neccesary. This past weekend (Sat.), I decided to change the hydraulic fluid and filter. Pure cream!!
I purged all that I could making sure that all cylinders were compressed. I let it drain all day.
Replaced approximately 14 gal. of oil and installed a new filter. I ran it all afternoon on Sunday doing snow fence work and it ran and work great. This moring (Mon.) It worked, when bucket was raised to back it out from the barn. It sat outside all day today, approx 18 degrees and when I went to park it back in the barn, none of the hydraulics now work.
There is a whining coming from under the floor of the tractor. The whine, changes from high pitched to low, loud to almost not even there. Is the pump shot or could it be that water/oil mix was trapped somewhere, where it could drain?
What should I do? Any suggestions are appreciated!
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
