|
Farmall & IHC Tractors Discussion Board |
Re: Farmall M live hydraulics conversion
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris in LNK NE on December 22, 2004 at 06:13:34 from (207.5.112.68):
In Reply to: Re: Farmall M live hydraulics conversion posted by Andy Martin on December 22, 2004 at 05:59:20:
Id considered (and still am considering) a factory addition, and have seen the commentary regarding the gear changes. Id also read on YT forums that the factory setup works great for low load stuff like 3-pt, but for loader, snow blower, and other high load things it is underpowered. Id also got a variety of GPM/PSI ratings for the factory pump from part dealers, which makes compatibility planning difficult. Cost is certainly a factor, as well. 18GPM@1500 rpm pump and drive system will be <$200, whereas the going rate for factory parts seems to be higher, but performance and reliability certainly are a higher priority. Thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
