Re: Cub - Crank Pully

Posted by Bigdog on December 31, 2004 at 12:39:24 from (24.160.187.179):

In Reply to: Cub - Crank Pully posted by RedMiller on December 31, 2004 at 12:20:18:

It is a press fit and it is usually very tight. A good puller and some heat will get them off. You must be careful though that when you use the puller, you do not pull against the flanges of the pulley as they will break before the pulley lets loose. Use a backer plate such as a bearing separator or similar set-up to pull against. Check the picture. The threads in the end of the crankshaft are 1/2" n.c.

Follow Ups:

• Re: Cub - Crank Pully El Toro 15:40:40 12/31/04 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]