Farmall & IHC Tractors Discussion Board |
Re: IH #35 Hay Rake
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Quebec Red on February 02, 2005 at 13:15:30 from (24.37.212.161):
In Reply to: IH #35 Hay Rake posted by dar on February 02, 2005 at 12:01:05:
The 35 rake was available with either ground drive or hydraulic drive. I have had both. The hyd. was a real deal, the agent being stuck with it out of season. A Farmall 350 did not do a good job as it had no oil cooler; Hydro 656 or 86 no better. The 706 did a fine job except in my line of hay equioment the 706 was needed elsewhere. Surprisingly, my 454 did a good job. This rake went down the road as trade for a Kuhn double rotor 3 PH rake. This was a very goog rake whem the transmission and cam assemblies worked. We became EXPERT Kuhn mechanics in repairing it in the field. This rake took a one way to the consignment sale. It was replaced by a 258 and a 260 NH rakes and a V hitch that worked very well making large windrows required for good round bales. I purchased then at auction a 35 rake, ground driven. In all fairness the NH rake could be run 1 to 2 miles an hour faster. I bought an L hitch and another 35 rake, permitting lots of raking capacity in variuos combinations from heavy first cut to soybean straw(36 feet per windrow). yes, the 35 is a good unit, make sure you have lots of hyd flow and a good cooler for the HY-TRAN. QR
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|