Farmall & IHC Tractors Discussion Board |
Re: Cub engine - oil pick-up screen question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on February 07, 2005 at 10:57:55 from (66.203.172.221):
In Reply to: Cub engine - oil pick-up screen question posted by Bama Binder on February 07, 2005 at 09:53:57:
Hey Bama Binder , I haven't seen you around for a while. You can get a tester to check actual oil pressure to ensure it is not a faulty oil pressure guage. I would persue what you are doing and check that no sludge has gotten into the pick up tube and pump. I had sludge build up on a B250 and I cleaned the pan and screen and now get consistent oil pressure. I was wondering if the pan had ever been dented in and straightened back out without checking the screen, it seems unusual for the screen to be bent up in, but over time it may have. Good luck with the job...Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|