Farmall & IHC Tractors Discussion Board |
Re: How much weight can a Farmall BN pull?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by williamf on February 08, 2005 at 19:07:51 from (66.82.9.76):
In Reply to: Re: How much weight can a Farmall BN pull? posted by ericlb on February 08, 2005 at 17:24:37:
I did that for my H when I wanted to pull a heavy trailer that had been made into a parade float. In the little mountain town, steep streets, small children, sorry old band brakes on the H. After we made it down my sister's driveway I didn't have to use it again, but it made me feel a lot better. I went to a trailer hitch store and bought a controller and wiring just like was installed in my Tahoo. Wired the controller sraight to the battery, mounted the seven wire plug on the pto handle. Didn't look all that bad, either. Wm
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|