Farmall & IHC Tractors Discussion Board |
Re: 10-20 Dimensions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harold H on February 09, 2005 at 17:01:59 from (67.141.169.145):
In Reply to: 10-20 Dimensions posted by Ben Van Veldhuizen on February 09, 2005 at 16:18:15:
I'm not sure which 10-20 you are talking about. IHC Titan 10-20, front wheel diameter 36", front wheel face 5 1/2", tread front 33", drive wheel diameter 54", drive wheel face 10", tread rear 46", wheelbase 91", total length 147", total width 60", total height 66 3/4", approx shipping wt 5710 lbs, export approx 7300 lbs, export approx meas'em'ts 230 cu ft. IHC McCormick 10-20, front wheel diameter 30", front wheel face 4 1/2", tread front 45 1/2", drive wheel diameter 42", drive wheel face 12", tread rear 48", wheelbase 78", total length 123", total width 60", approx shipping wt 4265 lbs. Hope this information helps. Harold H
Follow Ups:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|