Farmall & IHC Tractors Discussion Board |
Two Questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by '49 Farmall on February 28, 2005 at 15:49:25 from (24.50.150.86):
I have two questions with respect to the drawbar and cultivator assemblies for a Farmall Super AV. First off, will a standard farmall A or super A drawbar for an AV dimensionally? In other words, can I buy a straight A drawbar, and then have the drops and other high crop brackets made up to make it work instead of holding out for a complete high crop assembly (If you happen to know of a drawbar assembly for an AV let me know :) )? Second question, I have the mounts for the midmount cultivators for my super AV and the spring attachment to lift them from the touch control assembly. Will the toolbars from regular a/ Super A cultivators fit these mounts and does anybody know of anywhere that sells the toolbars separately with the shanks? I am located in Connecticut and will possibly drive 2-3 hours for the right equipment. I also need a complete set for the rear as well. Thank you for your help. Tom
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|