Farmall & IHC Tractors Discussion Board |
Re: IH 656D - TA issues cont.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tip on March 18, 2005 at 07:40:45 from (66.43.72.99):
In Reply to: Re: IH 656D - TA issues cont. posted by captaink on March 18, 2005 at 06:31:19:
Thanks CaptainK. To answer your questions: 1. I can visually see the direct drive clutch releasing. The TA linkage was adjusted per service manual and then I double checked the direct drive clutch clearance - at .035. 2. I adjusted the linkage yesterday and drove the tractor around. I am going to recheck the linkage and make sure nothing moved around. While its open, I am going to put a pry bar on her and see if I can turn it - gently.... 3. I too am guessing that a tractor split is in my future. I am probably going to run the tractor through haying season as is and then split her late fall. There are a couple of gears that are a little noisy, so I may be doing more than just the TA. Thanks again for your help. Regards, Tip
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|