Farmall & IHC Tractors Discussion Board |
Re: super m carb serial number
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by farmall on June 13, 2005 at 22:25:50 from (66.186.75.75):
In Reply to: Re: super m carb serial number posted by ChadS on June 13, 2005 at 09:01:22:
The super mta I just drilled the hole 2 sizes bigger and the plugs are really fowling, I can turn the jet screw in and the black smoke will be reuced but when I give it a shot of gas there isen't enough. You said something about the coil. I have a original style but new 6 volt coil, do I need to change it? When I put new plugs in the tractor runs like a million bucks but when it idless before it pulls it starts alot of black smoke and then it won't run worth a darn. I was just going to go back to a stock carb but it sounds like I wouldn't be using the money I already spent in the engine to its upmost potential which was my original goal. Now super h time, I put the spring in and the rpms are now plentyful. I checked the plugs after the pull and they were light black, so I'm asuming that it is getting more than enough gas. Is there anything else I should be donig to this tractor (timing) or am I close to the end. That govenor spring brought the life back to that super h. Its revs so hight that I can't get the idle down to a low idle, but that doesn,t worry me at all. Thank-you for your help it is greatly appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|