Farmall & IHC Tractors Discussion Board |
Re: Advice on IH 284
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ericlb on June 15, 2005 at 05:23:19 from (216.31.7.52):
In Reply to: Re: Advice on IH 284 posted by mowr on June 14, 2005 at 19:34:08:
we had one around for some years,[ gas mazda engine] i had to install a new head gasket on it, once, napa got it overnight, [head set] didnt have any other breakdowns with it, but we ran a 5 foot brushog on it, this seemed a little big for this tractor, as i had to make a bracket and hang some ih weights on the front of it, also ours did not have live pto, so you dont want to get near the fencerows or around buildings,trees ect, that or get a overrunning clutch for it,
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|