Farmall & IHC Tractors Discussion Board |
what head work is needed when ringing M???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scruffyia on June 30, 2005 at 09:04:44 from (206.195.193.254):
Now that you guys got me talked into putting rings in my M instead of having it done (the thread "what would you do with my 47 M") what head work is necessary when putting rings in an M? Can I just pull the head/oil pan off, remove rods/pistons, hone the cylinders, put new rings in the pistons, and putting it all back together with new gaskets? Or do I have to have the head plained? And if the head doesn't need to be plained is there any reason to pull the intake/exhaust manifolds? I'm trying to avoid that if possible, broken bolts from removing manifolds and me haven't gotten along well in the past.... Thanks, Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|