Farmall & IHC Tractors Discussion Board |
Cub making noise from transmission with clutch dis
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by GNB on July 04, 2005 at 16:52:24 from (64.12.117.13):
Finally got my engine in the 49 cub and she purrs like a kitten. Boy was I proud, first engine I have ever done. Another problem. I pushed the clutch in and there is a awful noise coming from the trassmission. I did notice when I turned the trasmission and clutch spline shaft that it had a wobble in it before I put the engine in the tractor. The release bearing and clutch was fine. The noise comes when the clutch is disengaged with trany out of gear and also when I engage the clutch when in gear. The tractor will move foward or backward but makes a awful noise from where the transmision and clutch shaft goes into the Tranny gear box. Could the shaft be bent? Or maybe bearings bad on the shaft. I bought the tractor not running so I dont know what was wrong with it before I got it. New at this so any suggestions would greatly be appreciated. How hard is the shaft to get out? Thanks. GNB
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|