Farmall & IHC Tractors Discussion Board |
Re: Power shows, and pulling,,, a question,,
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scruffyia on July 05, 2005 at 08:51:27 from (206.195.193.254):
In Reply to: Power shows, and pulling,,, a question,, posted by ChadS on July 05, 2005 at 08:33:47:
I sure hope that's not the reason for the pull being cancelled. If the pull was "stealing the show" it was also probably bringing in alot more people that would otherwise not have come to the event. Less people coming to a show equals less money coming into the event which unfortunately, alteast from what I've seen, results in smaller shows in the future. Personally I like looking at old tractors, be it restored, original, pulling, farm, etc. and would never hook my '47 M to a pulling sled. But at the same time I'd never completely restore my M, putting it back to original, either. It's a farm tractor and it farms. It'll pull a hayrack in a parade but other than that it doesn't get displayed much, it just works. My point being, to each there own. Some restore, some farm, some pull. In my mind it would benefit everyone and draw more people to appreciate our old tractors if we got along and played together. But if a group of people wants to display their tractors and exclude other peoples tractors, well, it's there show... I guess it's time for you to put on your own event and display your tractors. I know it's much easier said than done, but where there's a will there's a way. And if your tractors "steal the show" your event will be one to see! Just don't exclude other peoples tractors as you have been excluded. Make it open for all old tractors. In other words treat others as you want to be treated. later, mark.
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|