|
Farmall & IHC Tractors Discussion Board |
Re: Use for JB Weld ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 1031D on August 04, 2005 at 22:07:42 from (69.210.48.26):
In Reply to: Use for JB Weld ? posted by achodges1 on August 04, 2005 at 20:25:28:
I have a 1954 CASE VAC and the end cap for the steering box cracked out-it is similar to the big bearing retaining nut on my Farmall C and your Super C in the same spot. I built it back up with DEVCO? 2ton 2-part clear epoxy, filed and milled it to size and shape, not a lick of trouble. I have used JB weld to plug holes and seal cracked water jackets, but not shafts yet. I DEFINALTY RECOMMEND GETTING THE SHAFT AS ROUGH AS POSSIBLE SO IT STICKS!!! If you don't, it will just peel right off. Just my 2 cents
Follow Ups:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
