Farmall & IHC Tractors Discussion Board |
Re: just bought an 806
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by K.B.-826 on August 09, 2005 at 19:14:44 from (68.115.108.74):
In Reply to: just bought an 806 posted by mta on August 09, 2005 at 16:52:41:
From the factory, an 806 only has two guages- the tach on the left, and the fuel/water temp/AMP/OIL cluster on the right. If any part of that cluster is bad, the whole thing is junk. Usually the tube between the water temp sender and the guage gets damaged, ruining the whole cluster. If your temp guage works, check out the fuel guage- ground the wire going to the sending unit and put power to the other terminal, the guage should move to "full". If those two parts of the cluster work, it's good, since the AMP and OIL warning lights use common replacable light bulbs.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|