Farmall & IHC Tractors Discussion Board |
Re: inside diameter of front H M rims
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Janicholson on August 26, 2005 at 11:32:29 from (199.17.6.200):
In Reply to: Re: inside diameter of front H M rims posted by Nebraska Cowman on August 25, 2005 at 17:58:46:
Information is needed. Here is a guess ! If the hub onto which you want to put a new rim measures 1-1/2 ", and the bolt holes measure 3-1/4 between holes, !!And!! there are 5 lugs. Then you will have no problems finding rims. There are tons of cars with bigger center holes, and four and one half inch bolt circle (same as 3-1/4 between holes . Chrysler, Ford, full size, and many jeeps have them. Measure the bolt circle (the size of circle that will pass through the lug centers) for example a ford rim might be 14X5.5X5X4-1/2. This is a 14" wheel for 14" tires, with a 5.5 inch rim width (bead to bead), with a five lug pattern on a 5-1/2" bolt circle. Clear as yellow clay mud. good luck!! Jim Nicholson
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|