|
Farmall & IHC Tractors Discussion Board |
My H likes to Hunt--Governor question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Eastsider on August 29, 2005 at 18:25:43 from (24.111.66.65):
Hi all....I have a '41 H and everything works well, except for the
governor. When I rev it up quickly, it "hunts" revs up/down quite
a bit. If it is under a load, it works perfectly, and gives great
power. I ran it on the dynomometer last Saturday for 40
minutes or so to work in the rings. If it runs with no load, it will
hunt up and down. If I put a load on it it works great, full
throttle response. If I let off the load slowly, it will settle in and
keep a good rpm. If I let the load off quickly, it will hunt again.
We have set it to the specs in the manuals, replaced the spring,
etc... It is an all fuel manifold/head as original and it will put
out 28 HP. Does anyone have any suggestions to try? I guess
the weights may be sticky, but when we had it all apart, they
seemed to be alright. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
