Farmall & IHC Tractors Discussion Board |
Re: Super M letter codes
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John A. on September 08, 2005 at 20:36:43 from (65.161.170.18):
In Reply to: Super M letter codes posted by Cotton Picker on September 08, 2005 at 07:06:14:
Cotton, if you could post a pic of your tractor it would help. i will bet that yours is a Stage II Super M, since you didn't metion anything about a TA or LPTO. The 500 you made mention too, only applies to the Stage III SMTA models. Your tractor probably has the cross wise tank, With the Fill,Vapor,bleed, Liquid and vapor fuel valves faceing the rear of the tractor. The steering shaft goes through the tank. your tank setup will probably look like the tank on the W6, on page 107 of Guy Fays Letter series book. Now back, to the 500 IH SMTA LPs........ The tank is a longwise tank with the tractor. The steering shaft goes through it too. The one unusal feature is the valve assembly is a mono-valve setup @ the 11:00 position at the rear of the tank (while sitting un the seat) Not a series of valves strung across the side of thr tank. The SMTA LPs will carry the winged SMTA decal usually. Though I have seen a pic of what looks like A Stage II Super but has TA and LPTO. Most of those tractors came to Texas and the Deep South or where LP was popular. A Tank Company in Lubbock and San Angelo Texas was where the tractors were sent. There are No consecutive Serial #s. At least from what I have bee able to find out. Tractors were sent to The tank Companies on truck and then the trucks were loaded up with tank and sent back to the factor for compleation too. All the tractos were concidered Factory built. Not field conversion. Hope this helps. Later, John A.
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|