Farmall & IHC Tractors Discussion Board |
Re: Installing rear wheel weights
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by FarmerSid on September 21, 2005 at 04:47:46 from (130.15.62.140):
In Reply to: Installing rear wheel weights posted by jessboyd on September 20, 2005 at 18:58:55:
It sounds like you have the one piece 145lb round weights. I don't think anything is written in stone but I put them on with the rounded side facing in. That is with the cast center dished outwards. I then put the rest of the weights on the same way. You can use normal threaded rod to hold them on. If you use your 504 for pulling I would make a bracket that bolts on the cast center and then you can just slide the weights on it. Makes it much easier for puttting them on and off. If you want more info on how I made my bracket, let me know. Cheers! Sid
Follow Ups:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|