Re: Straightening wide front spindle

Posted by JB2 on September 24, 2005 at 14:09:05 from (69.196.154.214):

In Reply to: Straightening wide front spindle posted by Harley on September 24, 2005 at 10:01:40:

Hi Harley, the fellow that used to do all our welding would never staighten anything by heating it. He would take the cutting torch, cut a gap about 3/4 through the metal, then bend the item back straight and weld the gap closed. Never had one of his welds fail.

Good luck
JB2

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]