Re: IHC front axles

Posted by Jim J on September 25, 2005 at 08:19:57 from (65.222.50.185):

In Reply to: IHC front axles posted by MikeKy on September 24, 2005 at 18:24:23:

A quick fix that works is JB weld. Take the arms off and clean up the arms and spines. Put the JD Weld on the arm and put it onto the spindle. Put the nut on finger tight. Let them cure for 24 hours.Then tighten the nuts up. We have a 1066 that I did the spindles over 5 years ago that the arms are still tight on.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]