Farmall & IHC Tractors Discussion Board |
hydraulic pump capacity on 300U
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ron bond on October 02, 2005 at 16:08:34 from (216.168.96.86):
I'm putting a loader on my 400U, no easy task. The tie rods must be bent to go through the loader bracket, and now I either mount an external front pump on the front pulley, or use the existing hydraulis-which are strong. Ouestion is, are the hydraulics good enough to power a loader, with 2 way cylinders? Anybody know the pressure and volume of the 300U pump and will ift work? I have two rear remotes for a log spliter, can I tap into them to power the loader and still have them for the splittr/ thanks-ron
Follow Ups:
Home
| Forums
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|