Re: Casting code

Posted by Randy in NE on October 25, 2005 at 04:17:46 from (204.124.192.90):

In Reply to: Re: Casting code posted by Howard Magathan on October 24, 2005 at 19:29:33:

The casting code is a date that was engraved in the mold for some of the larger castings such as the rear-end/transmission, block, and torque tube. It would look like 10*25*W which is October 25, 1951. They used a letter for the year. A "ZA" would be for 1954 and an "A" for 1953, etc. The implements did not have casting codes. The best thing would be to find an owners manual for the implements for the 200. I had one for the implements for my C until I put it away prior to the cleaning lady showing up. It is now safely tucked away in my house somewhere.

Follow Ups:

• Re: Casting code Stan(VA). 04:58:31 10/25/05 (3)
  • Re: Casting code Randy in NE 10:56:24 10/25/05 (0)
  • Re: Casting code RustyFarmall 06:06:11 10/25/05 (1)
    • Re: Casting code Jim Becker 20:57:48 10/25/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]