Farmall & IHC Tractors Discussion Board |
Re: SA Touch control head gasket
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by farmallhal on October 30, 2005 at 12:58:34 from (64.24.35.17):
In Reply to: Re: SA Touch control head gasket posted by P and R Pete on October 30, 2005 at 10:13:09:
A Blue Ribbon serviceman's handbook, GSS-1024 is available on rebuilding the touch-control unit for the Super A, Super C along with the Cub. It can be obtained from www dot binderbooks dot com. It appears to be the most complete info available for rebuilding the unit that I have seen. I learned quite a bit by reading through it a few times. I've never rebuilt a unit but did some serious thinking about how to go about it after reading this book. The one thing which is repeatly stressed is cleanliness of everything during the entire rebuild. Most tools mentioned in the manual with the exception of a SE-1338-A pressure gage are likely found among your existing tools. It does mention a 1" and 2" micrometer along with an inside caliper will be required for checking for wear in the hydraulic pump. It mentions the need for Service Bulletin No. S-5550 to service the pump and block units. The GSS-1024 also has some good part breakdown pictures which identify the parts and assembly sequences. Hope some of this is helpful. Hal
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|