Re: crankshaft pulley

Posted by El Toro on November 13, 2005 at 17:50:41 from (205.188.117.73):

In Reply to: crankshaft pulley posted by RN in Misissippi on November 13, 2005 at 15:32:53:

You should've had a puller made like this using a hydraulic jack or ram. That pulley is a press fit. That's why it fit's so tight. You need to heat it in your oven at about 250 degrees in your oven. This will slightly expand the hub long enough for you to install the pulley.

With this puller you still need to use a split bearing separator behind the pulley to pull or push against. The flanges of the pulley will break easily. Hal
PS: Your local metal shop can make one for about
$35.00 and you would need to buy 3/4 allthread with flat washers and nuts. Here's a web site for salvageyards in your locality too.

http://www.ytmag.com/farmall/messages/459316.html

http://www.epartdirect.com/index.php?t=fc&s=s

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]