|
Farmall Tractors Discussion Board |
Re: Re: Re: Re: Re: DT466 from a cabover.. what (Besides a Zetor) will it fit?
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by matt hoscheit on December 30, 1999 at 15:49:43 from (204.73.44.124):
In Reply to: Re: Re: Re: Re: DT466 from a cabover.. what (Besides a Zetor) will it fit? posted by RickB. on December 30, 1999 at 15:17:40:
we use that 466 eng in alot of ag like was said of the 66 86 88 series ih you will have to cgange your front timing cover but not likely the plate that saves having to take out the camshaft out and don't worry about the oiling that is the same set up that tractor pullers run up to5000rpm and have no problems the combine does use the ag front timing cover but the rear is defferent that is were they put the starter the pan and pickup is also different and a combine dip stick is in the pan but the block has all that is needed to switch don't worry about the power any one with a dyno can lower the fuel detting and give you great service good luck you have a good motor there find it a good home
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
