Farmall & IHC Tractors Discussion Board |
Re: hydro pump mystery
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Peabody on November 25, 2005 at 18:00:05 from (64.12.117.13):
In Reply to: Re: hydro pump mystery posted by Hugh MacKay on November 25, 2005 at 14:56:29:
Thanks, Hugh. I'm about worn out with this one. I studied my parts catalog this afternoon and the Pesko pump shows an oil seal that says "optional" on certain pumps. I'm thinking Fenton may have a pump that actually has no seal, only the drive shaft running naked through the pump housing to the governor drive. That sounds like a problem waiting to happen. My advice would be to either have the pump machined to receive the seal he is going to get in the rebuild kit, or find a replacement pump, probably on Ebay or somewhere else, and use his rebuild kit on it, which will most likely be less expensive than the machining process.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|