Farmall & IHC Tractors Discussion Board |
Re: Starter butten
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dave from MN on December 12, 2005 at 16:10:18 from (208.252.179.22):
In Reply to: Re: Starter butten posted by K.B.-826 on December 12, 2005 at 15:48:21:
yes, ya have to have the foot n inch pedal in just like a clutch. It is positioned properly but I suppose I may have to do a make /break check on the switch next time. I am sure it will work fine now till I get 20' snow and -10. Which will probably be mid January when the flock goes out and the barn needs to be cleaned. Didnt have a single mechanical problem last year, got a feeling its gonna catch up. Preventative maintenance some how always loses to bad luck, my times a coming
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|