Farmall & IHC Tractors Discussion Board |
Re: Hugh
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on December 22, 2005 at 12:44:35 from (209.226.106.97):
In Reply to: Hugh posted by VaJerry on December 21, 2005 at 15:59:35:
Jerry: You've lost me somewhere, is the blade in your photo the one that is priced at $700. in PA? I took it to be the blade Scott was viewing. Somehow I think I'm wrong on both counts. Just think back to all that snow you shoveled. I can remember when Super A came out new. Two guys near our place each bought one of those blades with their new Super A's. I knew at a very young age what a great little snow plowing tractor these were. We plowed snow at home first with H then later 300. After we got the 130, dad was in village one day and saw one of these SA plowing snow. That night while milking the cows he said, " I think we plow our snow with wrong tractor, those little offsets make the big tractors look bad. I mentioned the village near our home farm, in the 1950s probably 100 homes, 3 general stores, bank, post office, church, hospital, etc. Three guys with three tractors kept drivways and parking lots cleared of snow. The three tractors were a Super A with factory blade, Super C with fabricated blade and a MF 35 with loader and snow bucket. Today there are probably 200 homes and same other buildings. Today it requires about a dozen 4x4 pickups, 2 skid loaders, couple of big tractors and a payloader to keep folks plowed out. I think the difference lies in the fact, the old timers from the 50s did not have coffee shops to sit around in and brag about how well they were doing against mother nature. I figure it takes about 10 times the hp per cubic yard of snow, in 2005.
Replies:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|