Farmall & IHC Tractors Discussion Board |
Re: anybody ever try this?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on December 27, 2005 at 19:02:27 from (64.228.11.93):
In Reply to: anybody ever try this? posted by john koritansky on December 26, 2005 at 05:48:45:
John: There is a down side to what your trying. Your Super A will have greater lifting capacity from a remote valve than from the rockshafts. I have seen remote valves installed on 100 and 130 with 1 point fast hitch, and a cylinder was used to power the hitch lift. This substancially increases the lifting capacity of that hitch, even though the rockshaft operated hitch had a spring assist. You can also use another comparison. The rockshaft operated fast hitch on a 100 or 130 have a lift limit near 500 lbs. The remote valve hitch on 200 and 230 will lift double that amount. Same basic hydraulic system on both of them. That rockshaft system will just not have the mechanical advantage required to do what you want. I don't think you will install this and have it a success for much less cost than a remote valve.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|