Farmall & IHC Tractors Discussion Board |
FARMALL H SHIFTING FORKS GEARS
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RICH on January 02, 2006 at 11:46:43 from (204.42.24.86):
Hi: Well, here we go again. I"ve got 6 times the money invested in my 8N but it finally works thanks to this website. Now I bought a "bargain" early 1940 FARMALL "H". First problem was the PTO shaft not working . We think we have that going our way now by replacing the entire unit up to transmission. Now we find the gears and shifting forks are worn badly (especially 4th & 5th gear and 1st & reverse shifting fork. The forks apparently change at serial # 19378. Our serial # is # 22500. Should be simple????? The part numbers on our shifting forks do not match anything in the shop manual although they come close to the numbers pre # 19378. What"s up with that? And would any forks we find for an H work? And any suggestions as to a reasonable place to obtain them? I"m finding the shop manual for this is either worthless or I"m not bright enough to understand it. I had a lot of good help on my 8N and am hoping the FARMALL guys are better. Thanks. Rich
Replies:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|