Farmall & IHC Tractors Discussion Board |
Re: Rebuilding IH 300 U Clutch and TA Questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Captaink on January 13, 2006 at 08:59:45 from (66.115.214.56):
In Reply to: Rebuilding IH 300 U Clutch and TA Questions posted by Roland Jackson on January 13, 2006 at 07:30:06:
Hugh is right the rebuilt TA is the quickest easiest way to go, however… I did rebuild my own on a 560 several years ago and it was a valuable learning experience. I got a rebuilt ramp and roller assembly (which was the problem with mine and in most TA’s) and rebuilt the whole thing myself. Not terribly complicated if you are mechanically inclined and have (or are willing to get) an understanding of planetary and sun gears in order to get it done. You will need a tech manual like IT or Blue Ribbon because the shafts and gears etc need to be in a specific way, and a clean working area and the proper tools and time.
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|