Farmall & IHC Tractors Discussion Board |
300 overhaul started / TA question as well
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rick/ Oasia ID on January 21, 2006 at 15:42:53 from (207.200.116.5):
I pulled the head today (169 engine)visually looks ok, a little carbon but not to bad. going to take Tractor Vets advice and do a complete overhaul,pistons, liners, bearings,valve job ect ect. I got the wide front off as well and pulled the pan. #1 rod bearing is completly gone so i'm gonna need a new or different crank. I didn't see where these guys sell cranks any ideal where to start looking. ( i rather not weld and grind this one if i don't have to) The TA lever and linkage was missing from the old girl when i got her, i assume it's been welded up or something but now would be the time to fix it if i'm ever going to. I'm hoping Tractor Vet or someone can tell me if it's likely to be to big/complicated a job for a novice like myself. i seen they sell rebuild kits for it for around 200.00 Thanks for any advice
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|