Farmall & IHC Tractors Discussion Board |
Re: f 20 stuck clutch?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Farmallgray on January 26, 2006 at 17:13:49 from (152.163.100.65):
In Reply to: f 20 stuck clutch? posted by mattd on January 24, 2006 at 19:23:31:
Something to think about. Every Regular, F-20 and F-30 I have torn apart had mouse nests in the clutch housing. It seems that timing mark hole is a perfect entrance for the little buggers. Before I got smart and started plugging that hole I had to tear my F-20 and regular apart multiple times to clean up and unstick the clutches. The last time I did my F-20 the clutch facing was actually rusted to the flywheel and pressure plate. It isn't that hard to take clutch apart on these tractors. Take the inspection plate off and look for nests. If you see any, it would be a good idea to tear it apart and clean it out.
Replies:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|