Re: S/C Bearings

Posted by Janicholson on February 05, 2006 at 08:01:07 from (66.173.50.101):

In Reply to: S/C Bearings posted by S/C Bob on February 05, 2006 at 04:36:18:

The bushing and bearing come out easily (as Gene noted). The use of a square edged socket (I buy a cheep bunch of sockets from the pawn shop and grind the edges to square them up, to use as a set of drivers)to drive the bearings out and in works well.
Do not pound on them (especially in the shield/seal, ou on the inner race of the ball bearing.) Brass hammer, perfect alignment to go in straight, and tenderness. It will go smoothly,
JimN

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]