Farmall & IHC Tractors Discussion Board |
McCormick loader question continued
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gentleman Farmer John on February 10, 2006 at 09:59:34 from (167.102.229.10):
Thanks for the information. Rusty, I wonder why the vent caps are present at the top of the cylinders if that end is to return oil to the belly pump? This is a lift only system I think, which is why I thought the vents were there. We have had this tractor for 50 years and it has always been set-up this way. It will lift pretty high minus the leaking oil from the right vent. I don't know that much about hydraulics, but I would guess once the pump pushes out its reserve of oil the loader would stop lifting. Correct? But at no time should it leak? I have a parts book for the H, but I don't think my grandfather ever had anything on the loader. Thanks again for everyone's information.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|