Farmall & IHC Tractors Discussion Board |
Re: Super A carb??
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on February 17, 2006 at 11:57:33 from (204.249.178.138):
In Reply to: Re: Super A carb?? posted by Jack in Ohio on February 17, 2006 at 06:41:50:
I have some data published by Zenith that lists some of their specs. Your number 375560R91 is a Zenith 161x7, which is part of their 161 series. So the carb on page 46 of your parts manual is similar to yours, although the IH number is different. The other carb is a 67X7, venturi is the same, jets are different. And, there is more than one version of each of these carbs. I do not know the effect of interchanging parts between these carbs, or how many actually fit. The safe way is to get the kit from Case-IH, if you do not have a local dealer, then Carter and Grunewald 866-327-6255. They will have your part number in their computer. I'm not saying the kit on this site is not as good, just that there are certain parts that I, personally, prefer to get from CIH.
Replies:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|