Farmall & IHC Tractors Discussion Board |
Re: Questions about I.H. tractor with Schramm Moto
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ol Chief on February 28, 2006 at 21:55:29 from (69.91.92.207):
In Reply to: Questions about I.H. tractor with Schramm Motor an posted by migraine on February 28, 2006 at 20:34:39:
Hey Migraine;Several months ago I posed a similar question.I also have a Schramm compressor and it is a pretty husky size four cylinder machine with two engine cylinders,the other two are complessors.This outfit appears to have been built by Minneappolis Moline.The valve tappet side cover is about twenty eight inches in length X four inches in width.Cast into the cover are two M M letters 3 inches high that stand out one half inch in typical Minne Moe style.It appears that no one here had ever seen one of these but the person answering my question said that he was sure that International had built some.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|