Farmall & IHC Tractors Discussion Board |
Re: IH 826 Torque Spec
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on March 07, 2006 at 10:52:16 from (64.179.117.47):
In Reply to: IH 826 Torque Spec posted by Donny on March 07, 2006 at 09:42:55:
Now lets see here your rebuilding and engine that is a diesel and you don't have a book for the spec's . Well what about sleeve protrushion or stand out have you checked the counter bores?? what about valve ression what about all the stuff that you forgot . I have been building engines since i was a teenager and one thing that i learned form some of the best is ya don't go by memory read the book and all new parts are not the same so ya got six new sleeves that does not mean that the lips are all the same heck i have seen them be thicker and inorder to get them set ya had to cut the counter bore deeper or it was cut to deep so ya had to shim it up . way to much money to waste on a job not done BY THE BOOK . It makes a world of differance on how well the rebuild lasts.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|