Farmall Tractors Discussion Board |
FARMALL C Grill and hood alignment
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by SHARKEY on January 11, 2000 at 19:05:52 from (207.27.2.98):
I have redone my 1950 Framall C with adjustable front axel. After painting it, I attempted to replace the grill and hood. First, I took it totally apart including the radiator, cylinder head etc. The grill bolt hole on the side does not line up with the two bolt holes in the bracket that comes from the front of the head and into the radiator. The grill is about 1 1/2 inches too high as if the raditor is too tall. I am sure I have the bracket on the proper way. Also the hood rises from back to front as it rests on the tank then travles upward to the grill. I did take to raditor to a place and have it reconditioned, but I don't think they gave me back the wrong one! ANyone have any thoughts? I am perplexed??????
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|