F-20 sleeves/pistons

Posted by JohnG(TX) on March 20, 2006 at 12:02:07 from (216.136.20.34):

I was talking to a friend this weekend about the possibility of boring out a set of shot F-20 sleeves to 4" and using M pistons in them. Has anyone done this or looked into this? I am wondering if the M piston pin height is close to the F-20, and how the thinner sleeves would hold up. Also, I am looking at the economics of the whole deal. Good sleeves are getting hard to find. I saw where there is a company in California making them, but at $200 each, that's too much for this project. I have an extra set of used 4" M flat top pistons I can use, and I was quoted $60 a hole for boring the sleeves. I guess I could sleeve the old sleeves after boring to reuse the F-20 pistons.

Replies:

• Re: F-20 sleeves/pistons Farmallgray 16:50:56 03/20/06 (2)
  • Re: F-20 sleeves/pistons JohnG(TX) 07:31:59 03/21/06 (1)
    • Re: F-20 sleeves/pistons Farmallgray 17:22:24 03/21/06 (0)
• Re: F-20 sleeves/pistons RegularRog 12:16:05 03/20/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]