|
Farmall & IHC Tractors Discussion Board |
Super M single wire
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jeffalex2 on April 06, 2006 at 15:41:34 from (141.157.57.168):
When I got the SM, it had been converted to 12volt neg gnd, and had an alternator that had been improperly converted to a single wire, and consequently burned up and killed the battery. I went to the NAPA, and they gave me a model 13-430 delco single wire and said it was perfect for old tractors and even has a smaller pulley for the lower rpm's. The resistance between the single wire and ground is 7000 ohms...not much bleed at all, but, it managed to drain the new battery down pretty bad in a week's time. I'm temped to just put a charging system switch on it and hide it somewhere...but am open to better ideas. The battery is under the seat so I am avoiding the battery disconnect at the battery terminal. Thanks for any help!!
Replies:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
