Farmall & IHC Tractors Discussion Board |
Re: BE CAREFUL WORKING ON THE TRACTORS
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on April 14, 2006 at 08:12:10 from (152.163.100.65):
In Reply to: BE CAREFUL WORKING ON THE TRACTORS posted by Thomas Windsor on April 13, 2006 at 15:17:49:
People that use a bumper jack and then crawl under their cars are flirting with serious injury or even death. There was incident it where I worked, but in a different section where they up loaded 120mm artillery rounds with more powder to see if the gun would withstand the pressure. This has been done for years without any problems. They remove the primer with a spanner wrench and add more powder and reinstall the primer with the same wrench until snug, then they used an air wrench to torque it. This man had his own way of of doing this, he used the air wrench to remove the primer and to reinstall it. Had been warned not to do that many times. On this day he was doing the same procedure and he was in a hurry to finish before lunch so he and his girlfriend could go eat. We heard a large explosion that was near us, but they're always firing guns so we didn't pay much attention until we saw firetrucks and ambulances heading that way. He and a co-worker were both killed, his girlfriend had stepped out to go to the bathroom a few minutes before the blast. The safety office conducted a test to see who was at fault. They took a shell without any powder or propellant and used an air wrench similar to one used on the explosion to remove the primer. It was cherry red when removed. A photographer that I knew was called to the scene to video and photograph the test cell. He said he didn't eat for a week. Hal
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|