Farmall & IHC Tractors Discussion Board |
Re: sickle bar for M model
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill WIneman on April 19, 2006 at 14:36:15 from (71.8.247.130):
In Reply to: sickle bar for M model posted by Rusty Wrecks on April 19, 2006 at 11:54:05:
Lots of old mowers will work. If you are not afraid of green, we have used old JD #5's and newer models on our Farmalls for years. The trick is to get or make the hitch plate that bolts to the drawbar. Any old hydraulic cylinder, single or 2 way will raise a mower. The pto shafts are all more or less the same, maybe a length problem but nothing that can't be fixed. The same type of hitch will work on C's if you bolt a regular dwarbar to the tractor. There was a pulley and cable arrangement to lift the JD mowers with a C that used the touch control unit.
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|