Farmall & IHC Tractors Discussion Board |
Re: power steering 300 U
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dellbertt on April 30, 2006 at 08:52:01 from (204.39.209.241):
In Reply to: Re: power steering 300 U posted by Wes in Ohio on April 29, 2006 at 17:02:20:
Wes, The tube coming out of the side of the front control valve is the front portion of the u shaped tube you are refering to. the back of the this u tube curves to the ps control valve at the rear which is inside the rear remote valve pictured. The length of your u tube will depend on how many remote valves you have. As you can see in the pic I have two valves in front and one in the rear. The ps valve is mounted inside the rear controler and the u tube fits into the rear of that. Because I have a front and back control valve my u tube connects to both the front and back then circles around to the back of the ps valve. Thats about as confusing as I can make it:-) Dell
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|