Farmall & IHC Tractors Discussion Board |
Re: Super A hydraulics levers controling throttle
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SAm in NS on May 10, 2006 at 13:52:38 from (217.72.182.153):
In Reply to: Super A hydraulics levers controling throttle posted by Todd in SE Ohio on May 10, 2006 at 13:08:17:
There should I believe be four bolts holding down the dash (with the ammeter, on/off switch, and light switch in it) which the steering wheel support and the hydraulic controls are mounted to. Two bolts go through the bottom into the torque tube, the other two go through the battery box and into the back (front) of the 'dash'. If the latter two are missing it could likely cause the fault you described. Hope this helps, SAm in NS
Replies:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|